Determine Location
We recommend a location near the center of the ceiling. If this isn’t possible, install at
least 4 inches from the wall or the corner. For wall mounting, select a spot not more than
12 inches from the ceiling.
NOTE: New construction: Do not attach device head until after sanding, painting, and other dust creating situations are finished and cleaned up.
Wiring / General
1. Use ANSI/UL Listed wire for Class 1 requirements
2.Observe local code requirements, and use box connector to anchor cable to outlet box
3.Metal outlet boxes must be grounded to earth ground
|
Turn off electricity to prevent ELECTRICAL SHOCK and damage to device. Be sure the alternating current (AC) power to the device is not controlled by any on/off switch, or other type of switch, other than a fuse or circuit breaker. |
IMPORTANT: Ensure that all fluorescent lighting fixtures are properly grounded.
NOTE: The wiring to be used shall be in accordance with the provisions of article 300.3(B) 210 of the National Electrical Code (NFPA 70). Wire installation should be performed only by a licensed electrician.
Comments
0 comments
Please sign in to leave a comment.